The built-in memory will clear after the step 3 of write sequence, so when do the write operation, make sure the file name you write to disk is different with the file exist in usb pen driver, otherwise, the file in usb pen driver will be covered by the new file from machine after the write operation.3. During the 8segment display d0 in read sequence, do not operate machine to readĭisk, the unit is not ready working with machine. The function of 2 button is IN and OUT data, when a usb pen driver plug on, the During the 8segment display d0 and d2, do not remove usb pen driver, the unit is transfer data with usb pen driver.4. Usb pen driver must be removed when change folder. Some model of machine: TMFD TME-DC etc only support the 2DD floppy disk(720Kb capacity), then only the model SFRM72-DU can be used. Swf embroidery machine floppy conversion driver#Ģ.Some of TFKN TFGN etc use a floppy driver model:YD-702D-6238, set the jumper as JP-A, if the model: YD-702D-6639 etc, set the jumper as JP-D. For SWF, Some of SWF can not start up, when a floppy disk insert. So when use GU model on these machines, please operate as these steps: plug a usb pen driver, keep IN button pressed, start up machine, when it in normal status release the IN button. If the problem can not be solved, please use SFR1M44-U100. Swf embroidery machine floppy conversion install#įor Chinese machine, we have a small printing circuit board for the front panel, if needed, you can install it. For BARUDAN BEMS BEMX, confirm if it support designs with both BARUDAN FDR format and TAJIMA format(.dst. dsb), if not, the conversion unit can not be used on it.
Swf embroidery machine floppy conversion driver#Ħ.If BARUDAN BEMS support TAJIMA format, store the design as file name start with 3 numbers, (for example 023***.dst 004.dst etc).Are the cables connected properly? Getting a constant green and red light at power up? Is the red side (pin1 side) of the ribbon cable towards the power cable? The SFRM72-DU only support TAJIMA format.Swf embroidery machine floppy conversion install#.
0 kommentar(er)
